According to the regulations of the State Grid, the proportion of distributed generation such as photovoltaics and wind power cannot exceed 10% of the grid, and the energy storage system must be added if it exceeds. Since photovoltaic systems and wind power systems do not use energy storage systems when they are connected to the grid for power generation, it will bring some adverse effects to the power grid. These effects become impossible to ignore. Through the analysis of the characteristics of photovoltaic power generation, it can be seen that the influence of photovoltaic power generation system on the power grid is mainly caused by the instability of photovoltaic power supply. The demand for energy storage systems has increased over the years.
The stable operation of the energy storage system is related to the safety and stability of the power grid, so the major energy storage system manufacturers attach great importance to its quality, and among the factors affecting the stability of the energy storage system, the heat dissipation performance is undoubtedly the most important. Trumony focuses on high-power heat dissipation and has rich experience in the R&D and manufacturing of heat sinks for energy storage systems. Trumony`s thermal management engineers can provide heat dissipation solutions from the beginning of the design of the energy storage system, and can also provide cooling solutions for energy storage systems. The system is optimized for thermal performance. By accumulating rich thermal design data, Trumony can provide accurate thermal simulation and thermal management test data.
snake tube for ESS,snake tube for energy storage,serpentine tube for battery pack Trumony Aluminum Limited , https://www.szaluminumtube.com
The water-absorbing operation of the sprinkler has certain requirements. During the operation, it is required to proceed.
(1) The sprinkler should be as close as possible to the operating point and parked.
(2) Open the side door of the walk-in box and take out the water-absorbing rubber hose so that it swings back without bending.
(3). Pull the water suction hose into the water as deep as possible to ensure that the end of the pipe is 300mm below the liquid level during the operation.
(4). Push the four-way valve handle vertically to the ground.
(5). Hitch the transmission to neutral, then start the engine, separate the clutch, pull the power take-off switch backwards to pull the file, and the pump starts to run.
(6) The operator can observe the upper part of the rear head. When the liquid level reaches the middle of the sight glass, the operator should be notified that the coworker should quickly pull the suction hose away from the water or close the four-way valve.
(7) After retracting the hose, return it to the walk-in box and close the side door.
(8) Driving the water truck away from the pumping location