Matthias Schoenberg, CEO of Continental Tire, confirmed that 16% of the shares previously held by Toyo Tire at the GTY joint venture have been held by Continental Tire and Yokohama Tire . At the same time, Continental Tire said that the company’s shareholding in the GTY joint venture has risen to 59%, and Yokohama Tire’s shareholding in the joint venture has also risen accordingly to 41%. On January 11, 2010, after Continental tires and Yokohama Tire stopped supplying tires from the GTY factory to Toyo Tyre and terminated its partnership with the GTY factory, Toyo Tire sued Continental Tyre and Yokohama Tires in the California District Court after request. Both perform cooperative agreements. At the time, Continental Tire and Yokohama Tire insisted that Toyo Tire & Rubber Co. Ltd., the parent company of Toyo Tire, had technology exchanges with its rival Bridgestone and used this as a Terminated cooperation with Toyo Tire at the GTY joint venture plant. In mid-January of 2011, Japan's Toyo Tire indicated that the company has reached an agreement with Yokohama Tire and Continental Tire. According to the agreement, Toyo Tire agreed to withdraw from the GTY Tyre JV and withdraw pending litigation and related arbitration. Toyo Tyre, Yokohama Tyre and Continental Tyre established a GTY factory in Mount Vernon, Illinois, in the United States in 1998, with a daily capacity of 7,300 truck and passenger car tires. It is reported that after the withdrawal of GTY by Toyo, Continental Tire and Yokohama Tire will produce a certain number of truck and bus radial tires for Toyo this year at the GTY plant.
High flux tube is a kind of high efficiency heat exchanger tube which sinters a layer of porous surface with special structure on the inner surface of ordinary heat exchanger tube by powder metallurgy method.
High flux tube can be classified into three groups: Sintered high flux tube, Sprayed high flux tube and Machined high flux tube. Among them, sintered high flux tube is the most expensive for its complex processing method and high efficiency; machined high flux tube is applied to mediums with high surface tension, its performance is in between; sprayed high flux tube is the cheapest for its easy process and low efficiency.
Compared with the bare tube, the sintered surface porous tube has the following advantages:
(1) it can significantly enhance the boiling heat, reduce the heat transfer area of about half, and have broad application prospects in the chemical and petrochemical plants such as large ethylene and large aromatics.
(2) in a very small difference in the maintenance of boiling, low taste energy recovery and low temperature boiling heat transfer has a great value, can be used to reduce the temperature of the heating steam.
(3) the critical heat load is more than 50% higher than that of the ordinary pipe.
(4) has good scale inhibition performance.
Copper High Flux Tubes,Aluminum High Flux Tubes,Stainless Steel Flux Tubes,Carbon Steel Flux Tubes Murphy Thermal Energy Co., Ltd. , https://www.murphyfinnedtube.com
• The holes in the surface porous layer are connected with the holes, which can significantly enhance boiling heat transfer. With grooves on the outer surface, the heat transfer effect can be increased by more than 10 times.
• High Flux Tube is tube element with the highest heat transfer coefficient up to now.